Force2Motion adapter system Motion Platform Plus - extension carrier (top)
The upper frame (F2M adapter system Motion Platform Plus extension carrier) is used to accommodate the Wheel Stands of the
NLR GTTrack Cockpit or the
NLR Wheel Stand DD or the
NLR Wheel Stand 2.0 and, together with a
V3, to form the cockpit, which can then be equipped with one or two
Motion Platform Plus. If this construct is to be mounted on a
Traction Plus, you will also need the F2M base support.
And the upper frame can also (alone - without the lower carrier) "transport" the NLR FGT cockpit (with and without NLR seat) to a Motion Cockpit. Here you can integrate one or two Motion Platform Plus and operate the whole thing "solo" with the original floor supports from NLR. And you can even strap the system onto a Traction Plus system. Pretty crazy, but it works.
The complete description of the product including all possible combinations and the weight restrictions when using a Traction Plus system can be found in the following PDF.
The
extension carrier (top) is needed for the following cockpits and motion platforms:
- NLR GTTrack Wheel Stand on Traction Plus (base adapter required)
- NLR Wheel Stand DD on Traction Plus (base adapter required)
- NLR Wheel Stand DD without Traction Plus
- NLR Wheel Stand 2.0 on Traction Plus (basic adapter required)
- NLR Wheel Stand 2.0 without Traction Plus
- NLR FGT Cockpit on Traction Plus (base adapter required)
- NLR FGT Cockpit without Traction Plus
Scope of delivery:
- 2x side member with holes in specified colour
- 4x end plugs in black plastic
- 2x cross member top/outside with thread at the head sides
- 2x upper cross member for upper floor panel
- 2x top floor panel as step protection, bracing and mounting for various cockpits
- 1x top cross member for mounting rocker (original pivot bar when mounting only one Motion Plus platform)
- Slot nuts, screws, nuts and washers
- Instructions in German (English in preparation)
Dimensions: approx. 1370mm x 575mm x 60mm
Net weight: approx. 11 kg
Attention: This is not a toy and not a fully assembled product! The offered article is a kit for a motion cockpit. Manual skills and tools (including a ratchet set, Allen key, open-ended spanner set) are required for assembly. Operation is at your own risk. Make absolutely sure that no small children or pets can get near the moving parts!
Please note:
- Motion platforms, Traction Plus, V3 etc and cockpits not included. The article presented here only contains the parts described under "Scope of delivery".
- When mounting the system on an NLR Traction Plus system, please note the maximum payload of 235 kg (incl. driver)!
- There are various options for this article, which are shown in the compatibility matrix.
Attention: Once again, because it is so important: The maximum payload of the Traction Plus System is 235 kg including all components mounted on it such as Motion Platform V3, Motion Platform Plus, cockpits and controls and of course the driver himself. This weight must not be exceeded, otherwise the warranty for the Traction Plus system will be voided!