Trak Racer

F2M Floor Plate Aluminium Cockpit

The F2M floor plate is installed in aluminium cockpits (e.g. Track Racer) and prevents the driver from stepping on the centre module of the NLR Traction Plus when the cockpit is mounted on it.

The plate consists of a 5mm thick folded aluminium sheet, powder-coated in black fine structure with corresponding holes for mounting on the aluminium profiles of the cockpit. The set is delivered with 6x screws and groove stones I-profile M8.

F2M Shifter Extension Short for Aluminium Cockpits

When installing a Next Level Racing V3 in an alloy cockpit, it can happen that the seat collides with a shifter mount on the alloy cockpit. For this purpose, a black anodised profile 80x40 shortened to 300 mm is offered, which replaces a standard profile (e.g. the 580mm one on the Trakracer 160).

F2M Adapter System Traction Plus for Aluminium Cockpits

With the F2M adapter system Traction Plus for aluminium cockpits it is possible to mount self-made cockpits or cockpits made of aluminium profiles on the Next Level Racing Traction Plus. IMPORTANT: The cockpits must have sufficient rigidity and stability so that they CANNOT bend in the middle when resting on the mounts of the Traction Plus system. The product consists of two adapters for the Traction Plus unit (front and rear identical) and a screw set. A cockpit or the Traction Plus System is not included.

F2M Adapter Set V3 Motion Platform for Aluminium Cockpits

With the F2M-Adapter Motion Platform V3 for aluminium cockpits it is possible to mount the Next Level Racing Motion Platform V3 in an aluminium cockpit e.g. of Trak Racer type 80 and 160. With the 160 cockpit (160mm overall height), the longitudinal profiles of the seat mount are omitted. With the 80 cockpit these are used (to obtain the necessary height / airspace for the V3). With the 160 cockpit the seat position increases by approx. 2 cm compared to the original seat, with the 80 cockpit by approx. 10 cm. For an inside width in the aluminium cockpit of 500mm.

The set consists of two aluminium brackets in black fine structure powder-coated for the V3 with 4 clamping screws. The inside of the bracket is equipped with a sliding strip so that the surface of the aluminium profiles is protected when the V3 is moved longitudinally.

Attention: When installing, make sure that there is sufficient air space for the fans of the V3 (approx. 2 cm distance to the floor and rear wall) and that the seat and, if applicable, a mounted butt-kicker can move freely without bumping into fixed parts or producing a crushing hazard for the hands. If a static shifter mount is used in the seat's movement area, it must be shortened so that the seat can move freely in all directions (this can be supplied by Force2Motion on request - see corresponding article).

Please Note: Cockpit and V3 not included.